مدیا کانورتور فیبر نوری تاینت ENTU 763C-GE

- Comply with IEEE 802.3, 802.3u, 802.3ab and 802.3z Ethernet Standard
- Support IEEE 802.3ah In-band and TS 1000 OAM management
-  Front panel test button to trigger auto loopback test
- Support SFP DDM (Digital Diagnostics Monitoring)
- Support WDM Bi-directional SFP module with specific wavelength for various distance
- Support copper line cable diagnostics feature
- Comply with IEEE 802.1q Tag VLAN
-  Support Q-in-Q function
-  Maximum Frame size 9K bytes
- Ethernet bandwidth Control
- Support Flow Control, Auto-Cross over for MDI/MDIX on TP port
- LED indicators for ease of network diagnostic
-  Support Link status Transparent
-  Prompt indication on network failure
-  Firmware upgrade via HTTP
-  Built-in IP-based WEB GUI configuration and maintenance
- Centralized management for CO-side equipment
-  iEAC-16 chassis supports 16 Line cards

Dimension:

- ENTU 763S: 87x 172 x 24 mm
Model Media Converter:
- ENTU 763S/GE, stand alone Gigabit Ethernet NTU
- iEAC-16, 2U 19” Rack, 16 slots for line card
Controller with NMS/WEB agent (MCU-16)
Hot Swappable Redundant AC/DC Power Modules (iEAC-AC or iEAC-DC)
Green FAN facility, ON and OFF by internal temperature(iEAC-FAN)
UP to 8 chassis can be cascaded and managed by single IP
- Line card ENTU 763C/FE, ENTU 763C/GE
Network Interface:
- Connector type: SFP-LC
- ENTU 763S/FE: 100Base-FX SFP modules
- ENTU 763S/GE: 1000Base-X SFP modules
- Support SFP DDM (Digital Diagnostic Monitoring)
Temperature, Voltage, Current, Tx Power, Rx Power
- For detailed wavelength and distance of SFP modules, please refer to SFP Transceivers
User Interface:
- Connector type: Shield RJ-45 jack
- ENTU 763S/FE: 10Base-T/100Base-Tx
- ENTU 763S/GE: 10Base-T/100Base-Tx/1000-BaseT
- Auto-MDI/MDIX detection
- Auto-negotiation for speed and duplex
- Full duplex / Half duplex support
- Support copper line cable diagnostics feature
- Complies with IEEE 802.1q Tag VLAN (including Q-in-Q)
- Ethernet bandwidth control and support Jumbo frame
Management & OAM Functions:
- Configuration via craft port VT-100 and WEB GUI
- Console: RJ45 connector (RS232C)
- HTTP firmware upgrade
- RMON counter
- Front panel test button for easy loop healthy testing
- Reset button back to factory default
Support IEEE 802.3ah Link Layer OAM:
- Auto discovery
- Link monitoring
- Remote loopback test
- Remote fault detection
Link Fault Reflection
Dying Gasp
Critical Event
- Support TS-1000 OAM
Loopback test
Reset remote device
Get remote device information
Remote port setting
LED Indicators:
- ENTU series:PWR, LNK, CO, TST, TP, RF, LAN LNK/SPD
Power Requirement:
- AC/DC, DC/DC external power adapter (12V, 0.5A)
- Power consumption:
ENTU 763S/FE = 1.8W
ENTU 763S/GE = 3.3W